Number of pits to be avoided in installation of elevator monitoring bridge

Number of pits to be avoided in installation of elevator monitoring bridge


This article comes from the security knowledge network. If there is any infringement, please contact our website to delete it in time.


Elevator is a complex closed environment, and the mature wireless monitoring has become the preferred application of elevator monitoring. The wireless bridge is the transmission equipment in wireless monitoring. It is easy to install and low cost. But in the actual elevator monitoring installation process, there will be many problems, here summarizes a few points, hoping to help you in the actual installation.




Hang I: Blind entrance?

Elevator belongs to special equipment, there is a certain danger, do not blindly enter.


One

Before installation, we need to go to the property to know the wiring of elevators, monitoring and so on.

Two

Contact the elevator maintenance personnel first, and the outside personnel must be led by the elevator maintenance personnel to enter (elevator operators according to regulations need to hold the special operation certificate issued by the State Administration of Safety Supervision in order to work).





Pit 2: How to solve the power supply of bridge?



Elevator brand is different, structure is different, car top and bottom configuration is also different. The power supply of the elevator car roof in the renovation project is very likely to be occupied by the camera. Where does the bridge get electricity? When surveying, pay attention to whether the top of the car is arranged or not. If there is no arrangement, another arrangement and insertion should be provided for easy access to electricity.





Pit 3: Where is the bridge installed?



The location of bridge installation should be avoided as far as possible, especially the metal material will affect the signal. The bridge on the top of the elevator car can be installed on the top railing; the other one on the foundation pit? It is possible that the foundation pit will accumulate water, affecting the bridge signal transmission, so fixing on the wall of the elevator shaft is the best way.





Pit 4: What is the bridge fixed with?



How to install the bridge fixed at the top or bottom of the elevator well? Bridge supporting equipment, many are only hoops or tie-ups, there is no support, so don't forget to buy brackets! When fixing the bridge with hoops and straps, the hoops should also be held tightly enough.






Pit 5: How to set up the bridge?



Most bridge configurations on the market:


One

WEB interface configuration:


First, the IP address is set in the WEB interface of two bridges, then the transmitter and receiver are set, and finally the channel is set.

Two

Dial-up Bridge:


Dial-up keys on the bridge, some of them represent work mode codes, group pairing codes, IP address codes. This pairing can be well completed only if the instructions are clearly studied.

Three

Digital Bridge:


The setting information is visually presented on the bridge, but it still needs to manually set the IP address and channel on the bridge, and then press the dial button of the bridge to match successfully.


The Youtep Elevator Wireless Bridge CP2-300 combines the advantages of dial-up and digital display bridges. It only needs one key pairing to set up successfully (one master, one slave and the same channel). The visualization operation is convenient and fast.


As an important wireless monitoring transmission equipment, the performance and correct use of wireless bridge is related to the normal operation of the whole wireless monitoring system. Therefore, users should know more about wireless bridges and choose brand products with reliable quality.


In order to meet the market demand trend, Youtep has introduced intelligent 2.4 G300M elevator monitoring special bridge and 5.8 G300M outdoor monitoring special bridge. Welcome to consult and understand.